Usage instructions:
Sterilisation Instructions: 1. Wash your hands thoroughly with soap and water, and dry. 2. Immediately after feeding, rinse out the bottle and teat with running water. 3. Wash the bottle and teat with hot water and detergent soap. 4. Use a bottle brush to remove any residual particles of feed. 5. Turn the teat inside out, wash with hot water and detergent soap, and flush water through the feeding holes. 6. Allow the parts to dry on a rack in a clean ventilated area. 7. Thorough sterilisation may be achieved by one of the following methods: Boiling: Submerge all bottles and parts (on a wire rack) in a pot of water, and bring to the boil. Boil for a minimum of 6 minutes. Using clean tongs, lift all parts from the water and place upside down on a clean towel to dry. Steam: Sterilisation Place all bottles and parts in a steam steriliser, or similar device, and follow the manufacturer's instructions. Microwave Sterilisation: Place all bottles and parts into a microwave steriliser, or similar device, and follow the manufacturer's instructions.

Warnings:
To protect your baby from harmful germs it is important to properly clean and sterilise your baby's feeding equipment. If you are breastfeeding your baby, using a feeding bottle and teat may interfere with the baby's natural way of suckling your breeast. For hygiene reasons, we recommend that the teats should be replaced at regular intervals. Check your teat each time you are about to use the bottle, this is especially important when your baby is developing teeth, Replace your teat when the first signs of damage become apparent

Information not available.